ABSTRACT

This work suggests an exact and systematic model identification approach which is
entirely new and addresses most of the challenges of existing methods. We
developed quadratic discriminant functions for various orders of autoregressive
moving average (ARMA) models. An Algorithm that is to be used alongside our
functions was also developed. In achieving this, three hundred sets of time series
data were simulated for the development of our functions. Another twenty five sets
of simulated time series data were used in testing out the classifiers which correctly
classified twenty three out of the twenty five sets. The two cases of
misclassification merely imply that our Algorithm will require a second iteration to
correctly identify the model in question. The Algorithm was also applied to some
real life time series data and it correctly classified it in two iterations.

 

 

TABLE OF CONTENTS

Title page……………………………………………………………………………………………………i
Certification……………………………………………………………………….ii
Dedication…………………………………………………………………………iii
Acknowledgement…………………………………………………………………iv
Abstract………………………….………………………………………………..vi
Table of content……….…………………………………………………………..vii
CHAPTER ONE: INTRODUCTION
1.1 Introduction ……….…………………………………………………………1
1.2 Statement of Problem……………………………………………………………..3
1.3 Significance of the study………………………………………………..…….4
1.4 Objective of the study……………………………………………………………..4
1.5 Scope and Limitation………………………………………………………….5
CHAPTER TWO: LITERATURE REVIEW
2.1 Introduction…………………………………………………………………….6
2.2 Review of Literature……………………………………………………………………………6
CHAPTER THREE: METHODOLOGY
3.1 The Bayesian and Fisher’s Classification Rule……………………………..12
viii
3.2 Distributional Assumptions..………………………….……………………….15
3.3 Development of the Proposed Classifier……………………………………….17
3.4 The proposed Algorithm………………………………………………………..18
CHAPTER FOUR: RESULTS
4.1 The Proposed Classifiers….…………………..……………………………20
4.2 Application of the proposed classifiers to simulated Time Series….………26
4.3 Application of our method to real life series………………………………..27
4.4 Brief comparison with other methods………………………………………28
CHAPTER FIVE: SUMMARY AND CONCLUSION
5.1 Summary……………..………………………………………………………29
5.2 Discussion of Results………….………………………………………….…30
5.3 Contributions…………………………………………………………………32
References…………….…………………………………………………………..34

 

 

CHAPTER ONE

INTRODUCTION
1.1 INTRODUCTION
Model identification is a crucial part of Time Series model development. The main
task of Time Series Modeling is to first examine the series at hand so as to
establish the theoretical model that generates the Series. This task seems to be the
most challenging and most ambiguous in Time Series Modeling. It has been
approached from different perspectives over time. One of the most popular
approach is the Box and Jenkins approach presented in Box and Jenkins (1976).
Their method involves going through some iterative steps before a final model is
selected. The initial step involves calculating the sample autocorrelation function
(ACF) and partial autocorrelation function (PACF) of the series at various lags and
comparing their behaviour with known behaviour of some theoretical model and
the model that best approximates the sample behavior is tentatively selected. There
are two serious problems with their method. First is the fact that one will need to fit
several models or do several adjustments to arrive at the final model. This makes
the method computationally expensive. Another serious problem is the inability of
the method to accurately differentiate between some classes of models. For
example, it is not easy to determine the values of p and q in fitting ARMA (p, q)
x
when p,q ¹ 0 since both the ACF and PACF tail off. However, Tsay and Tiao
(1984, 1985) addressed this problem by proposing the use of the extended
autocorrelation (EACF) and smallest canonical correlation SCAN respectively.
Tsay and Tiao methods are mere extension of the Box and Jenkins approach as
they involve comparing behaviour of sample EACF and smallest canonical
correlation with the theoretical behaviour. The difficulties in matching these
behaviour is even more in these approach because the clear cut off in theoretical
EACF table for example is hardly observed in sample EACF, Cryer and Chan
(2008).
Far away from the Box and Jenkins approach, Akaike (1969) and lots of other
scientists have done several works on various forms of information criteria. Their
approach is based on values calculated from residual of already fitted models. The
statistic calculated from residual of these fitted models is perceived as information
loss as a result of fitting the model. The order of the model that minimizes the
information loss is finally adopted. Model identification stage of time series
modeling has suffered severe deficiency over time. All the available methods are
deficient in terms of accurately selecting the model fit. There is no well defined
procedure that gives the exact model or at least with a known error margin before
going ahead to fit the model. The approach presented here is well spelt out rules
that guides model development. Some of the model identification approaches
xi
especially the Box and Jenkins approach is more of art than science as it is highly
judgmental.
The information criteria approach is not an exemption in this deficiency. Fitting
models with virtually all order before selecting a particular order is almost the
same as fitting all the possible models and selecting the one that passes the
goodness of fit test. Model selection is a stage that should be put to rest before
considering estimation, if one must come back to this stage then the initial
approach is supposed to have pre-specified the next model/order to consider. One
other important shortfall of the information criteria approach is that its results are
comparative meaning that only selected tentative models will have their
information criteria calculated compared and then the model with minimum
information criteria chosen as the best model.
In this work, we are proposing an exact model identification method which will
address most of the issues with available model identification methods. Our
method does not require fitting any model into series at hand before selecting the
right model. It will be capable of selecting the exact model with very high level of
certainty and in event where the selected model is not the appropriate model (since
there may be a small error margin); the method also predetermines the next model
(from all models under consideration) to be considered. With further
transformation as we have in this work, The behaviour of sample ACF and PACF
xii
is actually enough information for model identification. The choice of the lag is
informed by the fact that ACF and PACF of stationary ARMA models usually cut
off with higher lags. The ACF at lag 1 to 4 and PACF at lag 2 to 5 are the
information used in this proposed method. Our method utilized the variations
inherent in selected ACF and PACF in the classifiers and used them to classify
models as ARMA (p, q) with p + q £ 2 (with ARMA(22) added to demonstrate the
usefulness of our methods in cases of mixed models)
1.2 STATEMENT OF PROBLEMS
In Time Series analysis, there is need to establish the theoretical model to be fitted
into a particular time Series at hand before proceeding with subsequent steps, this
work particularly, seeks to develop a new method of achieving this.
In this work, we want to build discriminant functions for each of the classes of
theoretical ARMA models considered (i.e. AR(1), AR(2), MA(1), MA(2),
ARMA(1,1) and ARMA(2,2)) and also develop an algorithm which is a well
organized iterative steps to be followed in applying the functions. We equally hope
to test our new method out using both simulated and real life time series and
comment on its performance.
1.3 SIGNIFICANCE OF THE STUDY
Series of work have been done on time series model identification but all existing
methods are characterized with lack of precise problem formulation, presence of
xiii
heavy individual judgments, and associated high computational cost due to several
adjustments needed to arrive at the final model. Existing model identification
methods only give merely tentative and inexact perception of the appropriate
theoretical model before fitting hence several models are usually fitted at the initial
stage. This work is aimed at developing an exact model identification approach
which will address the challenges indicated above.
Our method is hoped to provide a systematic and well organized problem
formulation which will be capable of reducing computational cost and rigour
associated with time series modeling.
1.4 OBJECTIVES OF THE STUDY
This work is aimed at developing an entirely new model identification method
which addresses most of the challenges of existing methods. In achieving this, our
specific objectives are outlined below.
· To develop quadratic discriminant functions for each of the ARMA models
considered and define the iterative steps (algorithm) to be followed in
application of the functions.
· To apply the method to both simulated and real time series data.
· To briefly compare the proposed method with existing methods
1.5 SCOPE AND LIMITATION OF THE STUDY
xiv
This work is limited to six classes of ARMA models which are AR(1), AR(2),
MA(1), MA(2), ARMA(1,1) and ARMA(2,2). This method can only be applied to
those classes of ARMA model meaning that other classes of models like
Autoregressive integrated moving average model (ARIMA), seasonal ARIMA,
Autoregressive conditional heteroscedasticity (ARCH) models, Generalized
Conditional Heteroscedasticity Model (GARCH) etc. are not covered by our
method.

 

GET THE COMPLETE PROJECT»

Do you need help? Talk to us right now: (+234) 8111770269, 08111770269 (Call/WhatsApp). Email: [email protected]

IF YOU CAN’T FIND YOUR TOPIC, CLICK HERE TO HIRE A WRITER»

Disclaimer: This PDF Material Content is Developed by the copyright owner to Serve as a RESEARCH GUIDE for Students to Conduct Academic Research. You are allowed to use the original PDF Research Material Guide you will receive in the following ways: 1. As a source for additional understanding of the project topic. 2. As a source for ideas for you own academic research work (if properly referenced). 3. For PROPER paraphrasing ( see your school definition of plagiarism and acceptable paraphrase). 4. Direct citing ( if referenced properly). Thank you so much for your respect for the authors copyright. Do you need help? Talk to us right now: (+234) 8111770269, 08111770269 (Call/WhatsApp). Email: [email protected]

Related Current Research Articles